ssmc 3.6 file persona

[terminus]

hi to all

so
q: where is File Persona in ssmc 3.6.1.0.27 ??
or how to enable this block ?

ths

[MammaGutt]

I'm taking a guess on it not being visible because none of the systems have it enabled.

If you log on thru CLI and run "showsys -param" and look for ProfilePersona or something like you should see if it is set to "block-only" or "block-preferred".

What type of system do you have and what type of ports are you planning on using for file persona?

[terminus]

ths for your answer

showsys -param
System parameters from configured settings

--------Parameter-------- ----Value----
RawSpaceAlertFC : 0
RawSpaceAlertNL : 0
RawSpaceAlertSSD : 0
RemoteSyslog : 0
RemoteSyslogHost : 0.0.0.0
RemoteSyslogSecurityHost : 0.0.0.0
SparingAlgorithm : Minimal
EventLogSize : 4M
VVRetentionTimeMax : 336 Hours
UpgradeNote :
PortFailoverEnabled : yes
AutoExportAfterReboot : yes
AllowR5OnNLDrives : no
AllowR0 : yes
ThermalShutdown : yes
FailoverMatchedSet : yes
SessionTimeout : 01:00:00
HostDIF : yes
HostDIFTemplate : 3par_host_dif
AllowWrtbackSingleNode : 0
AllowWrtbackUpgrade : 0
DisableDedup : no
OverprovRatioLimit : 0.0
OverprovRatioWarning : 0.0
DisableChunkletInitUNMAP : no
PersonaProfile : block-only
ComplianceOfficerApproval : no
AllowR5OnFCDrives : yes
DisableCompr : no
RemoteCopyHostThrottling : no
SingleLunHost : no



now we have fc adapters only

so
how to enable file persona at cli ?

[MammaGutt]

If you only have FC adapter, how do you intend to access file persona? As far as I know the use of RCIP port has been deprecated.

You would need to use setsys command in CLI to change personaprofile and do a rolling node reboot for it to be applied.