We have a cage that was running fine and just went crazy yesterday ... we didnt upgrade or try to do anything is particular
When we run the following command checkhealth cage1 .. we get this ...
Component ---------------Description--------------- Qty
Cage Degraded or failed cage power supplies 2
Cage Degraded or failed cage power supply fans 2
Cage Cages not on current firmware 1
Cage Degraded or failed cage AC power 2
vlun Paths not reported by host agent 16
Component ---------------Identifier--------------- ---------------------Description----------------------
Cage cage:1 Firmware is not current
Cage cage:1 Power supply 0's fan is
Cage cage:1 Power supply 0 is
Cage cage:1 Power supply 0's AC state is
Cage cage:1 Power supply 1's fan is
Cage cage:1 Power supply 1 is
Cage cage:1 Power supply 1's AC state is
We also get some alarm going on that cage with leds flashing on the OPs Panel
System fault LED is steady Amber
Power supply/Cooling LED is Amber and Blinking
2 Gb Link Speed Link is Green but blinking
The Hub Mode LED is Green but Blinking
I'm swimming in the dark! Did i just lost a complete CAGE of Disk?