Its a bug where the port can get itself into a crazy factory test state. The Gui does not recgnise the port type property.
To fix it remove the SFP's then use the control port command in the CLi to change the port type. Then put the SFP's back in.
This bug can occur if you set up your 3par (smartstart OR out of box via serial) with the SFP's plugged in, (best to remove ALL connections apart from cat to management ports when settng up) or it can come from factory in that mode, especially in the early build models or on demo units.
_________________ PEAR-Motion
2xNode 3PAR StoreServ 7200 4xNode 3PAR Storeserv 7400 with LFF and SFF 2xNode 3PAR Storeserv 10400
|