Page 1 of 1
3par node 1 failed question
Posted: Thu Aug 04, 2016 3:52 am
by bunky1966
Hi both of our 3par arrays had Node 1 failures, but where resolved by the system?
Checkhealth all reports fine now, I find this a little worrying.
one happened on july 21st on one array and the other on aug 2nd on the other array.
Node 1 failed (node offline due to failure (oxd))
ID 59
State Resolved by system
Message code 0x01a00fa
does anyone know what this is before I call HP
Thanks
Mark
Re: 3par node 1 failed question
Posted: Thu Aug 04, 2016 12:53 pm
by rotorhead1
Is that the output from showeeprom or from showeventlog?
Re: 3par node 1 failed question
Posted: Wed Aug 10, 2016 9:57 am
by Namlehse
bunky1966 wrote:Hi both of our 3par arrays had Node 1 failures, but where resolved by the system?
Checkhealth all reports fine now, I find this a little worrying.
one happened on july 21st on one array and the other on aug 2nd on the other array.
Node 1 failed (node offline due to failure (oxd))
ID 59
State Resolved by system
Message code 0x01a00fa
does anyone know what this is before I call HP
Thanks
Mark
We had a similar issue, HP replaced the node. Haven't had a single issue since. The thought at the time was more than likely a failing SSD on the node. They couldn't be sure, so they replaced the whole node.
If you haven't had a node replaced before, word of advice. Keep a cheap Dlink/Netgear switch handy. The nodes replicate themselves across the network. For some reason ours never seem to work that way however.. Keeping a cheap switch resolved the issue. May not happen to you, but for some reason it hated our network.