both controllers stuck in reboot cycle
Posted: Thu Jul 11, 2024 11:49 am
I have an old 3par 8200 with a failed cage after a power outage/electrical problem.
I replaced the failed cage with a refurbished one. Now the cage and its disks seem to be ok, the problem is that both controllers are rebooting themself continuously. With a console cable I can see this text:
Loading PEIM at 0x000FFFD92A0 CpUPeim.efi
Loading PEIM at 0x000FFFCC2A0 PcatSingleSegmentPciCfg2Pei.efi
Loading PEIM at 0x000FFECDC20 PciCfgOnPciCfg2Thunk.efi
Loading PEIM at 0x000FFFD7220 PlatformInfo.efi
Bard ID = BoardIdTornadoNode
Waited 3500 ms for NEMOE boot
Turning off the enclosure because the node is on battery power. This will shut down the node until AC is restored.
Obviously AC power is available in both power supplies. Did I kill the nodes when I replaced the cage? What can I do now?
Thanks
I replaced the failed cage with a refurbished one. Now the cage and its disks seem to be ok, the problem is that both controllers are rebooting themself continuously. With a console cable I can see this text:
Loading PEIM at 0x000FFFD92A0 CpUPeim.efi
Loading PEIM at 0x000FFFCC2A0 PcatSingleSegmentPciCfg2Pei.efi
Loading PEIM at 0x000FFECDC20 PciCfgOnPciCfg2Thunk.efi
Loading PEIM at 0x000FFFD7220 PlatformInfo.efi
Bard ID = BoardIdTornadoNode
Waited 3500 ms for NEMOE boot
Turning off the enclosure because the node is on battery power. This will shut down the node until AC is restored.
Obviously AC power is available in both power supplies. Did I kill the nodes when I replaced the cage? What can I do now?
Thanks