HPE Storage Users Group

Hi dears
New 3PAR 7400 4 Node assembled on a rack .
interconnect cables between Enclosures has been done But nothing doing about interconnect cables between Nodes (A & C).
Today an idiot powered on all enclosures and Nodes(even not correct order) .
consider No configuration.(Nothing till now)
Now what do i have to do ?
- power off all enclosures , complete cabling and powering on in correct order
or
- while it is powering on , attach cabling between interconnect Nodes and complete cabling (Not powering off)

Any suggestion ? (please DO NOT consider calling HP)

I am not expert, but I don't think it is a huge deal, nothing is configured yet. At worst case the nodes will have a bunch of alerts. 2 options are wait for HP to get onsite and then have them serial in and cleanly shut down nodes or just power off.

If the 7400 has no configuration (OOTB has not been run) then you can power it off, re cable, power on and run OOTB.